© 2011 JVCKENWOOD Corporation
On day 18, he opened the model to adjust a column drop panel. SAFE loaded, but the model looked… different. The reinforcement contours were inverted. High moments showed as blue (low), low moments as red (high). He re-ran analysis. Same result.
He checked the tendon profile. It had changed. The drape points were now above the slab top surface. The software had silently edited his model. CSI SAFE 12.01 Portable.rar
The punching shear ratio now read: . Over capacity. But the reinforcement contour was inverted again. High demand areas had zero rebar. On day 18, he opened the model to adjust a column drop panel
Leo disconnected his laptop from the internet. He disabled Windows Defender. He copied the patch. He ran the executable. High moments showed as blue (low), low moments as red (high)
Then the cursor began to drift. Slowly at first—a pixel every few seconds—toward the top-left corner of the screen. Leo rebooted. The drift stopped, but now the file would not save. Every time he clicked Save , a dialog appeared:
Leo said nothing. He pulled out his laptop, opened the portable SAFE folder—which was somehow back on his desktop, timestamp modified 2 minutes ago—and ran analysis on the as-built model.
Leo opened the slab model to check the punching shear at an edge column. The software reported a value: (safe limit was 1.0). That was impossible. The slab would punch through like a bullet through butter.