New- Hints And Kinks For The Radio Amateur ★ Real & Easy

Use a second mat as a soldering iron rest when traveling. The iron tip won’t burn it, and it won’t slide off the table. A Final Word The best kink is the one you discover yourself. Keep a small notebook in your shack (or a digital note) and write down every “that worked well” or “that was stupid, don’t do it again.”

By WB2FAS (In the spirit of the original QST column) New- Hints and Kinks for the Radio Amateur

Buy a silicone baking mat (meant for cookies, about $10–15). They are heat resistant to 450°F, non-slip, and have a slight lip. The best part: the non-stick surface means solder balls don’t adhere—they just roll into a corner for easy vacuuming. Use a second mat as a soldering iron rest when traveling

Strip the insulation off a length of stranded hookup wire (16–22 AWG). Unravel the braided shield or simply flatten the stranded core. Dip the bare copper in rosin flux (paste or liquid). Apply your soldering iron to the joint and touch this makeshift wick to the molten solder. Keep a small notebook in your shack (or

This is for RF ground and equipment bonding , not for lightning or AC safety ground. Always keep your AC safety ground separate and intact. 8. Silicone Baking Mat = Portable Work Surface The problem: Tiny screws, washers, and springs roll off your bench and into the abyss (also known as the carpet).

Zero adhesive residue. Removes cleanly. UV and weatherproof for years. Temperature range: -60°F to +500°F. One roll seals dozens of connectors. Use it over electrical tape, not under. 5. The Ruler-on-the-Mast Trick (Antenna Matching) The problem: You’re tuning a 1/4-wave ground plane or a J-pole. You slide the radiator up and down, mark it with a Sharpie, lower the mast, adjust, raise again… repeat.